|
|
Talon
Disassembly Guide
Tools Needed
1 Phillips screwdriver.
1 Pliers or Adjustable wrench
- REMOVE AIR and hopper from marker. Take the 12g out of
the marker
- Using a phillips screwdriver, remove the eight (8) screws
on the outside of the body.
- Note that one screw is longer and goes through the air
intake behind the trigger
- Remove Valve Body, Hammer and hammer spring by pulling
on the back of the valve body.
- Pull hammer and spring off power tube (black tube)
- Remove brass valve cap with pliers or wrench.
- Watch out! A spring is in there!
- Inside, you'll find the Valve Oring (black oring),
Valve Seal (white seal at end of power tube) and
the valve spring
- Twist the bolt around and remove it from the pump arm.
Then pull it out of the marker.
- To remove the pump arm, if necessary, gently lift the
bolt carrier up and ove the barrel and pull it off the end
of the barrel
- Note the position of the trigger spring (Where it hits
the trigger AND the saftey) and remove it.
- Now pull the trigger and safety out of their holes
- To reassemble, go back in reverse order.
PICTURES coming soon!
Written by Kevmaster. Photos by Kevmaster.
|
